Reduce erosion

Reduce erosion

Category 02. Sediment flow quantity improvement

Expected effect of measure on (including literature citations):

• HYMO (general and specified per HYMO element)
• physico � chemical parameters
• Biota (general and specified per Biological quality elements)

Pressures that can be addressed by this measure

• Alteration of instream habitat
• Reservoir flushing
• Sediment discharge from dredging
• Loss of vertical connectivity
• Sand and gravel extraction
• Sedimentation and sediment input

Case studies where this measure has been applied

• Klompenwaard
• Meers - Floodplain lowering
• Doñana. Restauración del arroyo del Partido
• Sella
• Anzur. Intervención de mejora ambiental de un tramo del Río Anzur
• Deva River. Bank protection on the right bank of the Deva River in Molleda
• Upper Woodford - Demonstrating strategic restoration and management STREAM (LIFE05 NAT/UK/000143)
• Lower Traun
• Narew river restoration project

Other relevant information

Evolution of incised channels: Several conceptual models have been developed for the evolution of deep or incised channels (e.g. Schumm et al. 1984, Simon and Hupp 1986, Simon and Rinaldi 2006). These models can be used to assess the present stage of the river reach, which further morphological changes probably occur, and to select appropriate restoration measures. For example, if the reach is already downstream from the knickpoint and starts to widen (Fig. 1 stage IV), it might be an appropriate restoration measure to increase sediment deposition since there will be an increasing sediment input from upstream. Therefore, it is crucial to consider the state of the upstream and downstream reaches and to involve some geomorphological expertise in the restoration project.

According to the channel-evolution model of Simon and Rinaldi (2006) (Fig. 1):

• “One can consider the equilibrium channel as the initial, predisturbed stage (I),

• and the disrupted channel as an instantaneous condition (stage II).

• Rapid channel degradation of the channel bed ensues as the channel begins to adjust (stage III). Degradation flattens channel gradients and consequently reduces the available stream power for given discharges with time. Concurrently, bank heights are increased and bank angles are often steepened by fluvial undercutting and by pore-pressure induced bank failures near the base of the bank.

• The degradation stage (III) is directly related to destabilization of the channel banks and leads to channel widening by mass-wasting processes (stage IV) once bank heights and angles exceed conditions of critical shear-strength of the bank material.

• The aggradation stage (V) becomes the dominant trend in previously degraded downstream sites as degradation migrates further upstream because the flatter gradient at the degraded site cannot transport the increased sediment loads emanating from degrading reaches upstream. This secondary aggradation occurs at rates roughly 60% less than the associated degradation rate (Simon, 1992). Riparian vegetation becomes established on low-bank surfaces during this stage and serves as a positive feedback mechanism by providing roughness that enhances further deposition.

• These milder aggradation rates indicate that recovery of the bed will not be complete and that attainment of a new dynamic equilibrium (stage VI) will take place through further (1) bank widening and the consequent flattening of bank slopes, (2) the establishment and proliferation of riparian vegetation that adds roughness elements, enhances bank accretion, and reduces the stream power for given discharges, and (3) further gradient reduction by meander extension and elongation. The lack of complete recovery of the bed results in a two-tiered channel configuration with the original floodplain surface becoming a terrace. Stormflows are, therefore, constrained within this enlarged channel below the terrace level and result in a given flow having greater erosive power than when flood flows could dissipate energy by spreading across the flood plain.”

Fig. 1 Stages of channel evolution (from Simon and Rinaldi 2006)

Literature on evolution of incised channels: Simon, A. and Hupp C.R. (1986) Channel evolution in modified Tennessee channels. Proceedings, Fourth Federal Interagency Sedimentation Conference, Las Vegas, March 24–27, Vol. 2,. 5–71 – 5–82.

Simon, A. and Rinaldi, M. (2006) Disturbance, stream incision, and channel evolution: The roles of excess transport capacity and boundary materials in controlling channel response. Geomorphology,79, 361-383.

Schumm, S. A., Harvey, M. D. & Watson, C. C. (1984). Incised channels: Morphology, dynamics, and control. Littleton, Colorado.